Clear-Com BP410 - User Manual

Quick Reference Guide
BP410
1. Battery
2. Increase Volume button (
▲
)
3. Decrease Volume button (
▼
)
4. PWR (Power) button
5. Headset cable connector
6. Battery-release latch
7. Power/Mode lights
8. Channel A (Intercom 1) button - Includes 2-wire and
4-wire connections
9. ISO (Isolate) button - To All Wireless Headsets and
Beltpacks, Base, ISO Relay and AUX OUT
(if activated)
10. Channel B (Intercom 2) button - Includes 2-wire
and 4-wire connections
The Beltpack Beltpack Setup
7 78 9 10
21 64 3 5
Part Number: 399G214 Rev A
Date: 12/5/16
Copyright © 2016 Clear-Com, LLC, an HM Electronics, Inc. company. All rights reserved.
Clear-Com, the Clear-Com logo and Clear-Com Concert are trademarks or registered trademarks of HM Electronics, Inc.
Battery
RELEASE BATTERY button
Belt clip
Headset
cable plug
¾ Insert a fully charged battery in each Beltpack with the
metal contacts inserted rst. Slide it in until it snaps.
NOTE: The battery will not slide in if inserted
incorrectly. Excessive force should not be necessary.
¾ Plug the Beltpack’s headset cable connector into each
Beltpack.
BP410 Beltpack Settings
To Set:
All functions are from an off state. Press the Power button and release with the
appropriate buttons below.
ISO restrict On A button
ISO restrict Off A button and ISO buttons
Handsfree On selected button(s) A button and/or B button and/or ISO and Volume up button (▲)
Handsfree Off selected button(s) A button and/or B button and/or ISO and Volume down button (▼)
Listen-Only mode On Volume down button (▼)
Listen-Only mode Off Volume up button (▲)
To Set: With the power already on...
Increase mic gain (15 steps) Press the B button while repeatedly pressing the Volume up button (▲)
Decrease mic gain (15 steps) Press the B button while repeatedly pressing the Volume down button (▼)
Increase sidetone level (5 steps) Press the A button while repeatedly pressing the Volume up button (▲)
Decrease sidetone level (5 steps) Press the A button while repeatedly pressing the Volume down button (▼)

Clear-Com BP410 Specifications

General

Brand	Clear-Com
Model	BP410
Category	Intercom System
Language	English

Summary

The Beltpack

Beltpack Setup

BP410 Beltpack Settings

General Use

Beltpack Sidetone Adjustment

Adjusts the audio level for the beltpack's sidetone via button presses.

Changing the Battery

Instructions on how to remove and replace the beltpack's battery.

The DX410 Console

Register Beltpack

Procedure for registering a beltpack to the base station.

AUTO NULL Adjustment

Adjusts audio for 2-wire interface to reduce echo in wireless beltpacks.

Local Headset Communication

Controls for selecting communication channels and adjusting local headset volume.

Technical Support