Cleco 55 Series - Cleco Nomenclature and Model Breakdown; Tool Series and Model Identification; Tool Rotation, Type, and Throttle Options; Gearing, Head, Spindle, and Drive Configurations

Page 2
823104EN
06/05/2015
Cleco
®
Nomenclature
55 X N X XX - XX X X - X
Tool Series
55
Tool Rotation
-- = Non Reversible
R = Reversible
Tool Type
N = Nutrunner
Torque Control Mechanism
-- = Stall Type
A = Clecomatic Clutch
J = Joint Rate Clutch
Throttle Type
L = Lever Throttle
RT = Roll Throttle
Gearing Designation
2 6
3 7
4 10
Right Angle Head
M = Square Drive, Threaded or Flush Socket Spindle
P = Square Drive or Flush Socket Spindle
T = Square Drive, Threaded or Retractable Spindle
THD = Hold and Drive
VHD = Hold and Drive
Spindle
-- = Non Retractable Spindle
R = Retractable Spindle
Output Drive
3 = 3/8" Square Drive S = Built-in Socket (specify size)
4 = 1/2" Square Drive T = Threaded Spindle
“A”