en01d441_bedingt.fm, 12.01.2017 P2174HW-EN 2017-01 7
Set-Up Guide
1
2. Abb. 1-3: illustrates the bolt pattern for hanging the mounting plate on a wall. Note the hole size
dimensions so the correct size bolts are chosen. Size ¼“ or M6 bolts (4) should fit the mounting plate
holes and support the controller.
3. Once the mounting plate is installed in its location the controller can be hung on the bracket utilizing
the four studs protruding from the back of the controller. Once in place, the controller can be secured
at the bottom using the two long screws removed in Step 1.
1.7 Making Connections to the Controller
1. Connect the cable to the tool.
2. Connect the other end of the cable to the controller. The connector at the controller is an Air-LB con-
nector and utilizes a push-pull style connector. Before attempting to attach the cable verify that the
collar on the controller connector is pushed towards the controller. If the collar is pulled away from the
controller the cable will not connect to the controller. Insert the cable connector and pull the collar
away from the controller (towards the cable) to lock the cable in place.
3. Insert the power cord into the controller and into a 115 or 230 VAC power source.
4. Using the ON/OFF power switch at the front of the controller power the controller ON.
To Next Page
Loading...
Need help?
General
