Clevo W170ER - Processor Removal and Installation

Disassembly
2 - 12 Removing and Installing a Processor
2.Disassembly
Removing and Installing a Processor
Processor Removal Procedure
1. Turn off the computer, remove the battery (page 2 - 5) and the component bay cover (page 2 - 6).
2. The CPU heat sink will be visible at point (Figure 8a) on the mainboard.
3. Remove screws
, , , , and , the reverse order indicated on the label. *Note: Make sure that the
size of the screwdriver is below 4mm when removing or tighting screw , and its position should be at a 90
degree angle from the mainboard (Figure 8b).
4. Carefully lift up the heat sink off the computer by pulling the two tabs .
A
6
5
4
3
2
1
5
B
D
Figure 8
Processor Removal
a. Remove the cover and
Iocate the heat sink.
b. Remove the screws in
the order indicated.

B. Heat Sink
• 6 Screws
a.
1
2
3
A
b.
5
4
6
5
B
D
D

Caution
The heat sink, and CPU
area in general, contains
parts which are subject to
high temperatures. Allow
the area time to cool be-
fore removing these parts.