Clevo W230SD - Installing and Removing the SSD Module

Disassembly
2 - 16 Installing and Removing the SSD Module
2.Disassembly
Installing and Removing the SSD Module
SSD Module installation procedure:
1. Turn off the computer, turn it over, remove the battery (page 2 - 5), component bay cover (page 2 - 10) and 3G
(page 2 - 15).
2. Carefully remove the screw
(Figure 12a).
3. The interface adaptor will pop-up, and you can remove it from the computer (Figure 12b).
4. Insert the SSD module (Figure 12c), and you can tighten the screw (Figure 12d).
1
2
3
4
b.
c.a.
1
3
d.
2
4

Antenna Cable
Pay attention, and be careful not to damage
the antenna cable on the side when installing
the module or interface adaptor.

2. Interface Adaptor
3. SSD Module
•2 Screws
Figure 12
SSD Module
Installation
a. Remove the screw.
d. Remove the interface
adaptor.
c. Install the module.
d. Tighten the screw.