Clevo X7200 - Storage Device Management

Disassembly
2 - 24 Removing the Hard Disk from the Secondary HDD Bay
2.Disassembly
1. Remove screws - from the hard disk assembly (Figure 19a).
2. Grip the tab and slide the hard disk assembly in the direction of the arrow (Figure 19b).
3. Lift the hard disk assembly out of the compartment (Figure 19b).
4. Remove screws - from the hard disk assembly (Figure 19c).
5. Separate the hard disk from the HDD case (Figure 19d).
6. Insert the replacement HDD into the case *Make sure the cable connector is facing towards the rear of the
case as illustrated below.
1
4
5
1 2
5
3 4
6
7
8
9
a.
b.
c.
d.
11
10
Figure 19
Removing the
Hard Disk from the
Secondary HDD
Bay
a. Remove screws from
the hard disk assem-
bly.
b. Grip the tab and slide
the hard disk assem-
bly in the direction of
the arrow . Lift the
hard disk assembly
out of the compart-
ment.
c. Remove screws from
the hard disk assem-
bly.
d. Separate the HDD
from the HDD case.
5

10. Hard Disk
11. Hard Disk Case
•8 Screws
6
9
10
11