Climate Wizard CW-H15 - Turning the Cooler On; Checking Fan Operation; Checking Pump Operation; Checking Drain Operation

COMMISSIONING
Settingthe AirDischargeDamper
AirBalancingprocedureforCOLDFRONTCooling:
AirBalancingprocedureforSUPPLEMENTARY Cooling:
a. ConnectallexternalductworktotheClimateWizardinpreparationforbalancingthesystem.
b. Ensuremain AirConditioningplantfansarerunningatfullspeed-consultwithBuilding
Managerand/or AirConditioningcontractor.
c. StarttheClimateWizardinMANUAL andVENT modesonfullspeed.
d. AdjusttheClimateWizarddamperuntilthepressureinthetransitionstabilisesasfollows:
CW-H10 240Pa
CW-H15 215Pa
e. Proceedtobalancetheexternalductandoutletsinyourusualmanner.
f. Checkandifnecessaryre-adjusttheClimateWizarddamperbacktotheabovevalues.
g. Lockthedamperinitsfinalposition
a. ConnectallexternalductworktotheClimateWizardinpreparationforbalancingthesystem.
b. IncaseaductisattachedtotheClimateWizarddischarge,setthelouvresindesiredposition.
c. Ensuremain AirConditioningplantfansarerunningatfullspeed-consultwithBuilding
Managerand/or AirConditioningcontractor.
d. StarttheClimateWizardinMANUAL andVENT modesonfullspeed.
e. AdjusttheClimateWizarddamperuntilthepressureinthetransitionstabilisesasfollows:
CW-H10 240Pa
CW-H15 215Pa
f. Proceedtobalancetheexternalductandoutletsinyourusualmanner.
g. Checkandifnecessaryre-adjusttheClimateWizarddamperbacktotheabovevalues.
h. Lockthedamperinitsfinalposition
CW CW
COLDFRONTCOOLING
AC AC
CW
SUPPLEMENTARY COOLING
AC
19
SeeleyInternationalPtyLtd
TurningtheCooleron
TESTING THE COOLER
Once you are satisfied that the Cooler is installed and commissioned correctly, run it to ensure that everything is working as it
should.
Press the button to start the cooler. Press the button to toggle between “Cool” and “Vent”on the display to switch
the pumps on or off . Vent mode disables the pumps. Check that the cooler runs quietly and with a balanced distribution
of air to all outlets.
Pressthebuttontotogglebetween“Cool”and“Vent”onthedisplaytoswitchthepumponoroff .With
controlin“Cool”mode,checkthatthereiswaterbeingpumpedwithinthecooler. Thisismosteasilydonebyobservingthe
waterturbulenceinthevicinityofthepumps.
Ensure there are no water leaks. Drain the reservoir by pressing both the and buttons together , with the
wall control in the “OFF” state. Check the drain fittings and pipes, making sure there are no leaks.
(Fig. 1)
(Fig.2)
(Fig. 3)
Turning cooler on, check fan operation
Checkpumpoperation
Check drain operation
859736-A AU1007