MODEL FL-20A
Cable Fault Locator
R
eels of rejected multi-conductor and shielded cable sit-
ting on the production oor are an expensive problem.
Until now, nding opens and shorts with an analog cable
fault locator took expertise and patience, since the procedure
required tedious meter and sensitivity adjustments as well as
mathematical calculation once the test was completed.
The digital FL-20A automates cable fault detection,
greatly reducing the time and training required to nd these
problems. Opens, metallic shorts, or high voltage shorts
between conductors or between conductor and shield are
pinpointed quickly and with ease. The operator simply con-
nects the FL-20A test probes to each end of the cable under
test, enters the cable length on the digital touch screen, and
selects “Shorts” or “Opens” to begin the test. The unit
quickly calculates the distance of the fault site from each test
probe, displays the location in feet or meters, and provides
a suggested trim area. The failure can then be cut out or
repaired and the remaining good product salvaged, resulting
in great savings to the producer.
>> Quickly locates opens, shorts and high
voltage shorts in cable lengths
>> Fully automated testing
>> Simple to operate
>> Color touch screen
>> Compact, lightweight unit
>> CE approved
The FL-20A Cable Fault Locator, a compact 15”W x 14”D
x 10”H weighing only 38 lbs., is signicantly smaller and lighter
than its predecessors. It promises a great return on investment
by salvaging expensive cable assemblies and lowering the costs
associated with salvage.
Sample display screens
To Next Page
Loading...