Need help?Do you have a question about the Clinton HF-15B and is the answer not in the manual?
Digital High Frequency Sine Wave Spark Tester with key features.
Details on available bead chain, brush, and roller electrode assemblies.
Diagrams and measurements for various mounting and display configurations.
Explanation of safety symbols and environmental operating conditions.
Precautions for fire risk, pacemaker interference, ozone, and electrical shock.
General cautions for installation and steps for unpacking the spark tester.
Guidelines for selecting location, mounting on surface, or floor stand.
Steps for installing RC Display and providing ventilation for the Test Module.
Procedures for connecting power, external disconnect, and grounding the spark tester.
Information on connecting auxiliary equipment via terminal blocks.
Instructions for connecting the spark tester via RS-485 serial interface.
Details for optional Analog and CompactCom Module connections.
Instructions for unpacking and connecting the optional X3B accessory.
Description of ON/OFF switch, voltmeter, buttons, and fault counter.
Explanation of FAULT light, High Voltage Lamp, and Reset buttons.
Details on the Clear Protective Cover and Safety Interlock Switch.
Definitions for Actual Voltage, Fault Pulse, Pinhole, Metal Contact, and Gross Barewire.
Definitions for Latch, Non-Latch, Remove Voltage on Fault, and Watchdog.
Details on the detachable display and front panel password security.
Overview of optional communication modules and DSP based fault typing.
How to navigate the configuration menu and use panel buttons.
RC Display security, PIN configuration, and available menu options.
Configuration settings for PIN, Fault Detection, Sensitivity, Line Speed, and RS-485.
Input to enable high voltage by connecting pins 1 & 2.
Input to reset the spark tester fault relay with an external switch.
Outputs for Cover Open, Unit Malfunction, and Voltage Monitoring.
Fault Pulse, Any Fault Alarm, Pinhole Alarm, and Metal Contact Alarm configurations.
Configuration for Multi Pinhole and Gross Barewire Alarm outputs.
Settings for fault count limits and Any Barewire Alarm.
Definitions for Pinhole, Direct Metal Contact, Multi Pinhole, and Gross Barewire faults.
Step-by-step instructions and critical cautions for performing product testing.
Ensuring product is dry, grounded, and properly positioned before testing.
RS-485 connector pinout and default serial port parameters.
Description of functions and notes for each analog interface pin.
Parameters and addresses for Fieldbus communication interfaces.
ST-CAL and HF-CAL calibration procedures, including connections and readings.
Steps to adjust output voltage and monitor values for accurate calibration.
Procedure for calibrating using an Electrostatic Voltmeter (EVM).
Information on fuse locations and guidelines for periodic inspection of electrodes.
Cautions for troubleshooting and steps to resolve phantom faults.
Troubleshooting steps for specific error codes (E.EXI, E.CVO, E.RVF, E.RVC, E.HVD, XMRE).
Resolving relay output issues, unit non-functionality, and setting factory defaults.
Why grounding is necessary for D-C, A-C, and mains frequency spark testing.
General| Brand | Clinton |
|---|---|
| Model | HF-15B |
| Category | Test Equipment |
| Language | English |
To Next Page