Model HF-15B High Frequency Spark Tester
HF-15B Instruction Manual – Page 11
Installation
CAUTION:
The installation procedures listed below are to be performed by qualified
service personnel only. Failure to follow these procedures may result in danger
to personnel and equipment damage.
Unpacking
Remove the spark tester from the carton. Retain the packing material in the
event that the unit is returned for calibration or service at some future time.
The following items are packed with the spark tester:
1. HF-15B Spark tester
2. RC Display With mounting bracket (when ordered)
3. A power cord
4. A 9-Pin green terminal block connector for process control connec-
tions. After it is wired, it will plug into the terminal block on the
back of the spark tester
5. A 4-Pin green terminal block connector for process control connec-
tions. After it is wired, it will plug into the terminal block on the
back of the spark tester
6. RS-485 connecting cable 1 Foot Long
7. Quick Start Guide
8. Short Manual
To Next Page
Loading...