34
Installation
5.7.2 Tank provided by a third party
When using a third-party tank, it must fulfil the following requirements:
• The tank thermistor must be placed above the heat exchanger coil.
• If possible, the additional heater should be located under the T5. In cases where this is not possible,
always install a domestic hot water recirculation pump.
• Choose built-in heaters with double safety protection with manual and automatic reset thermostat in
accordance with the requirements of EN 60335.
O
WARNING
Third-party tank performance data cannot be provided and performance cannot be guaranteed. Use
CLIVET tanks and accessories for optimal performance.
L
NOTE
The unit is standard supplied with a 10m long temperature probe. A probe of up to 30m long can be
ordered as an accessory (not recommended).
To Next Page
Loading...
Need help?
General