6"
"
water is controlled by the hot control at a proper temperature. In case of overheating, the heat limiter
will operate automatically.
C. Function of Parts
① Compressor: Compresses the vapor refrigerant sucked from the evaporator and discharges it to
condenser
② Condenser: Changes the compressed vapor refrigerant into the liquid refrigerant by cooling.
③ Drier: Removes moisture and dirt inside pipes
④ Capillary tube: Reduces the pressure of liquid refrigerant and evaporates it in the evaporator
under constant pressure.
⑤ Evaporator: Absorbs the surrounding heats while evaporating the liquid refrigerant, cools down
water inside of cold water tank.
⑥ Cold water thermostat: Senses the temperature of cold water tank and controls the electric power
supply to the compressor automatically in order to keep the constant temperature of cold water.
⑦ Over Load Protector (OLP): Protects the compressor and operates when rising up to abnormal
temperature or energizing over current.
⑧ PTC Starter: Starts up the motor of compressor.
⑨ Cold water baffle: Separates the supplied water from cold water, hot water, or room temperature
water respectively.
⑩ Hot tank heater: Heats the supplied room temperature water to hot water.
⑪ Hot control: Controls the temperature of hot water at a proper automatically.
⑫ Heat limiter: Cuts off the electric power to the heater in case of overheating.
⑬ Hot water switch: Supplies or cuts off the electric power to the heater by setting it ON/OFF.
⑭ Drain cap: By opening this, you may drain out remaining water in hot water tank when cleaning
or not using cooler for a long period of time.
3. LOCATION REQUIREMENTS
A. Locate cooler in a well ventilated space where temperature is never below 0.
B. Maintain a minimum clearance of 4 inches on sides and rear of cooler for proper ventilation.
C. Make sure installation ground is flat and even. - Unbalanced placement may cause excessive
noise and trembling of the cooler.
D. Coolers are for indoor use only. Keep away from direct sunlight and excessive moisture.
E. Avoid harmful gas or excessive heat.
4. INSTALLATION PROCEDURES
A. Install drip tray below faucet.
B. Thoroughly clean the cooling tank and baffle. Baffle must be in exact place for proper cooling
operation.
CAUTION: IF THE COLD WATER BAFFLE IS REMOVED, COLD WATER WILL NOT BE FORMED NOR
To Next Page
Loading...
Need help?
General
