7"
"
DISCHARGED.
C. Put standardized bottle filled with water on top of the product.
Use drinking water only. Filling the unit with any other type of beverages may cause significant
problems.
D. For hot water activation, stay holding down hot faucet handle until water flow is continuous and
clear.
E. Place the hot water switch on the "ON" position.
(Check the available power supply against the cooler specification plate to ensure correct electrical
service.)
CAUTION: FAILURE TO FILL HOT TANK WITH WATER BEFORE SWITCH ON HOT WATER CAN CAUSE
PHYSICAL DAMAGE TO THE COOLER.
F. Cooler will be ready to serve you Cold & Hot water in 30 minute after installation.
G. Hot Water Safety Faucet: A safety faucet deters accidental dispensing of water by toddlers. (Korea,
US patented)
CAUTION: WATER FROM HOT FAUCET IS EXTREMELY HOT AND MAY SCALD.
5. STORAGE
A. Switch off hot water switch. Unplug power cord.
B. Drain hot water by opening faucet. Then, do the same on cold water faucet.
C. Place a bucket behind the drain pipe. By unscrewing the drain cap counter clockwise, drain the
remaining water in the hot water tank. When tank is emptied, dry drain cap and the end of drain
pipe. Close draining pipe with cap.
D. When storing, ensure it stands on its erect position on the flat and even ground. (Do not lay the
product on its sides down or upside down.)
E. When not use for a long period of time, conduct product cleaning before you put in storage.
CAUTION: FAILURE TO ABIDE BY ABOVE PROCEDURE MAY INCUR PHYSICAL DAMAGE ON THE
COOLER.
CAUTION: WATER FROM HOT FAUCET IS EXTREMELY HOT AND MAY SCALD.
6. CLEANING
A. Do the same as A to C procedure for storage.
B. Remove baffle in cold water tank.
C. Remove faucets from the product. Both faucets are disassembled by turning them counter
clockwise.
D. Wear disposable gloves (clean and safe material for drinking water).
To Next Page
Loading...
Need help?
General
