Page 48
VILLAGER 2+2 LSV ELECTRIC
Operators Manual
TPCC01VS00EN017 (Edition A)
DAILY PRE-OPERATIONAL SAFETY CHECKLIST
INSPECTION
AREA
INSPECTION CRITERIA
General
• Make sure that all parts are correctly installed.
• Make sure that all nuts, bolts, and screws are tight.
• Replace missing, worn, or damaged items.
Decals
• Make sure all safety, regulatory, and marketing decals are correctly
installed.
• Clean the decals with a soft moist cloth.
• Replace missing, worn, or damaged decals.
Tires
• Examine for wear and damage.
• Replace worn or damaged tires.
• Inflate tires as necessary.
Seat Belts
• Examine seat belt straps for damage.
• Examine seat belts for loose parts.
• Replace missing, worn, or damaged items.
• Make sure that the seat belt latch plate clicks when pushed into the
buckle. Pull up on the latch plate to make sure it is secure.
Batteries
• Make sure that all battery hold-downs are tight.
• Make sure that the battery cables are correctly attached. Tighten as
necessary.
• Examine the battery posts for corrosion. If corrosion is found, remove the
corrosion.
• Make sure that the batteries are fully charged.
• Examine the battery acid level. Add deionized or distilled water as
necessary.
• Replace missing, worn, or damaged items.
6
Vehicle Operation
Daily Pre-Operational Safety And Performance Checks
To Next Page
Loading...
Need help?
General
