Mixing tank
Everyday, after
work
Washing with warm
water with detergent,
washing and drying
(sponge rubber)
Cleaning and washing
only with the power off
External surfaces
Everyday, after
work
Washing with warm
water, strong stream
of hot water
Avoid direct contact of
water with electrical
components (control
panel)
Table no. 4.
Washing
type
Alkaline and
disinfection
Acidic Additional
disinfection
Surface care
Purpose Washing and cleaning Change of
enviromental pH
and removal of
mineral deposits
Additional
desinfection after
performing the
acidic foam washing
Polishing and
surface care
Frequency Everyday, after work Once per week Periodically, after
performing the
acidic foam washing
Periodically
Method
Washed surfaces coat
evenly with the foam,
leave the foam for 15-
20min (according
recomendation of
preparation producer) on
surfaces. Hardly
contaminated places
clean with brush, rinse all
surfaces with water flush
(vertical surfaces rinse
from up to down) Visually
inspect the effectiveness of
cleaning
Proceed as for
washing with
alkaline agent
Washed surfaces
coat evenly with
disinfectant solution,
leave the solution
for 15-20min
(according
recomendation of
preparation
producer) on
surfaces, rinse all
surfaces with water
flush
Spray surfaces
evenly with
preparation and
then spread it
with a soft cloth
Table no. 5.
8.3. Periodic inspection, adjustment, repair.
Action
Frequency Procedure
Checking for leaks in the chamber
between the tank and the drive shafts
chamber
Everyday, after work
Unscrew the knob integrated
with the lid, check - visual
inspection. When replacing O-
rings space between them
should be filled with grease
approved for contact with food
Tightness of gear motor Once per month
Visual control through the
window in gear motor body- if
needed add oil
Chain tension Once per month Clearance measured in
midway between the two
sprocket wheels must be
approximately 5 mm. Adjust by
turning the nut on the bolt
9
To Next Page
Loading...