mDT001 HazMon System Tester Technical Manual /14
CMC INDUSTRIAL ELECTRONICS LTD
Phone: (604) 421-4425 Toll Free: (888) 421-4425
Fax: (604) 421-7734
www.cmciel.com sales@cmciel.com
The Industry Leader
in HazMon Technology
9. Press the “SELECT” key to save the new values to the sensor. The display will indicate;
10. Once the configuration has been saved the display will indicate;
11. Press the “BACK” key to exit sensor configuration.
The parameters that can be configured are fully described in the Technical Manuals for the individual
sensors.
3.6 Battery Gauge
The battery gauge function displays the remaining capacity of the batteries in percent.
The tester uses 2 AA batteries that are located in a battery compartment in the rear of the tester. The
tester will remain active even if the battery indicator drops to 0%. The sensor reading may not be
accurate if the batteries are further discharged. Replace the batteries at 10% to ensure you have
adequate battery power when the tester is needed.
3.7 Battery Gauge
The battery gauge function displays the remaining capacity of the batteries in percent.
The tester uses 2 AA batteries that are located in a battery compartment in the rear of the tester. The
tester will remain active even if the battery indicator drops to 0%. The sensor reading may not be
accurate if the batteries are further discharged. Replace the batteries at 10% to ensure you have
adequate battery power when the tester is needed.
Saving config
> > > > > > > > > > >
To Next Page
Loading...