EasyManuals Logo

CMi C-EKS-2000/35 User Manual

CMi C-EKS-2000/35
Go to English
224 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
GB
46
Original instructionsElectric chain saw
Table of contents
Before you begin… . . . . . . . . . . . . . . . . 46
For your safety . . . . . . . . . . . . . . . . . . . . 46
Your device at a glance . . . . . . . . . . . . . 50
Assembly . . . . . . . . . . . . . . . . . . . . . . . . 51
Operation . . . . . . . . . . . . . . . . . . . . . . . . 52
Cleaning and maintenance . . . . . . . . . . 55
Storage and transport . . . . . . . . . . . . . . 56
Faults and remedial measures . . . . . . . 56
Disposal . . . . . . . . . . . . . . . . . . . . . . . . . 56
Technical data . . . . . . . . . . . . . . . . . . . . 57
Claims for defects . . . . . . . . . . . . . . . . 219
Before you begin…
Intended use
This device may only be used with the
approved original cutting chain for sawing
wood.
This product is not intended for commercial
use. Generally acknowledged accident pre-
vention regulations and enclosed safety
instructions must be observed.
Only perform work described in these instruc-
tions for use. Any other use is improper. The
manufacturer will not assume responsibility
for damage resulting from such use.
What are the meanings of the symbols
used?
Danger notices and information are clearly
marked throughout these instructions for use.
The following symbols are used:
These symbols identify the required personal
protection equipment:
For your safety
General safety instructions
To operate this device safely, the user
must have read and understood these
instructions for use before using the
device for the first time.
If you sell or pass the device on, you must
also hand over these operating instruc-
tions.
General power tool safety warnings
Save all warnings and instructions for
future reference. The term power tool in
the warnings refers to your mains oper-
ated (corded) power tool or battery oper-
ated (cordless) power tool.
Work area safety
Keep work area clean and well lit. Clut-
tered and dark areas invite accidents.
Do not operate power tools in explo-
sive atmospheres, such as in the pres-
ence of flammable liquids, gases or
dust. Power tools create sparks which
may ignite the dust or fumes.
Keep children and bystanders away
while operating a power tool. Distrac-
tions can cause you to lose control.
Electrical safety
Power tool plugs must match the out-
let. Never modify the plug in any way.
Do not use any adapter plugs with
earthed (grounded) power tools.
Unmodified plugs and matching outlets
will reduce risk of electric shock.
Avoid body contact with earthed or
grounded surfaces such as pipes, radi-
ators, ranges and refrigerators. There
is an increased risk of electric shock if
your body is earthed or grounded.
Do not expose power tools to rain or
wet conditions. Water entering a power
tool will increase the risk of electric shock.
DANGER! Direct danger to life and
risk of injury! Directly dangerous sit-
uation that may lead to death or
severe injuries.
WARNING! Probable danger to life
and risk of injury! Generally dan-
gerous situation that may lead to
death or severe injuries.
CAUTION! Possible risk of injury!
Dangerous situation that may lead to
injuries.
NOTICE! Risk of damage to the
device! Situation that may lead to
property damage.
Note: Information to help you reach a
better understanding of the processes
involved.
WARNING! Read all safety warn-
ings and all instructions. Failure to
follow the warnings and instructions
may result in electric shock, fire and/
or serious injury.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CMi C-EKS-2000/35 and is the answer not in the manual?

CMi C-EKS-2000/35 Specifications

General IconGeneral
BrandCMi
ModelC-EKS-2000/35
CategoryChainsaw
LanguageEnglish

Related product manuals