GB
56
The bearing of the chain wheel should be reg-
ularly lubricated at the front-end of the rail.
About 1× in a week in case of intensive use.
– Clean the lubrication hole.
– Apply little multi-purpose grease in the
lubrication hole, while moving the chain
with hand.
Sharpening the saw chain
Storage and transport
Storage
• Let the device cool down before you store
it.
• Store the device as horizontally as possi-
ble.
Longer downtimes
If you are not going to be using the device for
a while, remove the chain oil from the device.
Store the device in a dry place.
Transport
If you are transporting the device in a vehicle:
– Slip the protective cover onto the cutting
tool.
– Secure the device against slipping.
– If possible, use the original packaging for
dispatching.
Faults and remedial measures
When something isn’t working…
Malfunctions are often caused by minor
faults. You can easily remedy most of these
yourself. Please consult the following table
before contacting the vendor. You will save
yourself a lot of trouble and possibly money
too.
If you can’t fix the fault yourself, contact your
nearest vendor. Please be aware that any
improper repairs will also invalidate the war-
ranty and additional costs may be incurred.
Disposal
Disposal of the appliance
A crossed-out wheelie bin icon
means: Batteries and rechargeable
batteries, electrical or electronic
devices must not be disposed of with
household waste. They may contain
substances that are harmful to the environ-
ment and human health.
Consumers must dispose of waste electrical
devices, spent portable batteries and
rechargeable batteries separately from
household waste at an official collection point
to ensure that these items are processed cor-
rectly. Information on returning these items is
available from the seller. Sellers are required
to accept these items free of charge.
Batteries and rechargeable batteries,
which are not permanently installed in
waste electrical devices, must be
removed prior to disposal and must be
disposed of separately. Lithium batteries and
battery packs in all systems must only be
retuned to a collection point when dis-
charged. Batteries must always be protected
against short circuits by covering the poles
with adhesive tape.
All end users are responsible for deleting any
personal data stored on waste devices prior
to their disposal.
Disposal of the packaging
The packaging consists of cardboard
and correspondingly marked plastics
that can be recycled.
DANGER! Danger of death! A worn
or improperly sharpened chain can
cause rebounds. Severe or even fatal
injuries can be the result!
Note: Special tools are required to
sharpen the saw chain; these guaran-
tee that the cutting of the chain occurs
at the correct angle and the correct
depth. We recommend that you have
the saw chain sharpened by a profes-
sional.
DANGER! Risk of injury! Make
sure that unauthorized persons do not
have access to the device!
DANGER! Risk of injury! Improp-
erly performed repairs can lead to the
device not functioning safely. This
endangers yourself and your environ-
ment.
Fault/malfunction Cause Remedial measure
Motor not running. No mains voltage? Check cable, plug, socket and
fuse.
Cable faulty? Contact your local vendor.
Is the device defective?
To Next Page
Loading...
Need help?
General
