Your device at a glance
30
C-GP 1000X V_02/05/2009
GB
Your device at a glance
1. Air intake duct
2. Filler plug
3. Pressure joint
4. Handle
5. On-Off switch
6. Water drain plug
Scope of delivery
•Garden pump
• Instructions for use
Unpacking and commissioning
Setting up
• The device must be placed on a horizontal, level surface that is sufficiently capable of support-
ing the total weight of the device when filled with water.
• To prevent vibrations, the device should be placed on an elastic base [support] (e. g. a rubber
mat).
• The installation site must be well ventilated and protected from the effects of weather.
• When being used on garden ponds and swimming pools, the device must be set up so as to
guard against overflowing and protect against falling in. Additional legal requirements must be
observed.
Connect suction line
• All connections must be sealed with hemp and thick paste (Fermit) or thread sealing tape (e. g.
Teflon tape); leaks cause air exhaust and reduce or prevent water exhaust.
• Hemp should be used in case of pipe threads from metal; synthetic thread must be sealed with
thread sealing tape.
• All parts of the suction pipe must be assembled properly.
• The suction pipe should have an internal diameter of at least 1 inch; it must be kink resistant
and suitable for vacuum use.
Risk of damage to the device!
The suction line must be installed so that it does not exert any mechanical force or ten-
sion on the pump.
If the conveying medium is contaminated, a suction filter must be used to protect the
pump from sand and dirt.
Note:
A check valve is recommended so that the water does not run off when the pump is shut
off.
4
3
2
1
6
5
Gartenpumpe_C-GP_1000x.book Seite 30 Montag, 25. Mai 2009 12:52 12
To Next Page
Loading...