Operation
32
C-GP 1000X V_02/05/2009
GB
Operation
Filling and intake [suction]
1. Unscrew water filler plug together with seal.
2. Slowly pour in clean water until the pump is filled.
3. If you want to shorten the intake time, fill the suction line as well (only possible with the check
valve).
4. Screw water filler plug and seal back in.
5. Open pressure line (turn on water spigot or nozzle), so that air can escape during intake.
6. Switch the device on.
7. When water runs out evenly, the device is ready for operation.
Operation
The pump and suction line must be connected and filled.
1. Plug in the mains plug.
2. Turn pump on at the On-Off switch.
3. Open pressure line (turn on water spigot or nozzle).
4. Check to be sure that water is coming out.
If the motor does not start up or the pump does not build up any pressure or if similar faults occur,
turn the device off and try to remedy the error (▸ Faults and remedial measures – p. 33).
Maintenance
Risk of damage to the device!
The pump should be filled with water after each new connection or in the event of water
loss or air intake. Extended operation without a water refill (unsupervised dry run) will
destroy the pump!
Note:
We recommend installing a check valve between the pump and suction line, so that the
water column remains in the suction line.
We recommend using a suction filter for better suction performance.
▸ Accessories – p. 35
Danger of damage to the device!
The pump must not be allowed to run dry. Sufficient conveying medium (water) must be
on hand at all times.
Danger of damage to the device!
Do not allow the pump to run longer than 10 min. when the pressure line is closed.
Allowing it to run longer can result in overheating and damage.
Mortal danger due to electric shock!
Disconnect the mains plug before carrying out any work on the device.
Gartenpumpe_C-GP_1000x.book Seite 32 Montag, 25. Mai 2009 12:52 12
To Next Page
Loading...
Need help?
General