5
■To test your engraving machine
◆Installing the control software
·Software is not included in this machine, so please purchase appropriate software in line
with your fondness; It is recommended to use Mach3 to control it;
·Please carefully read the instructions about installation in the Mach3 software manual
before installing the software.
Attention: do not open it after installing the software. You must first reboot the
computer immediately, and then open the software for settings.
After restart the computer, The two files are copied to the installation directory, and replace
the original file.
◆software parameters settings
Please refer to the following pictures for software parameters setting:
①
To Next Page
Loading...
