11
ENGLISH
Troubleshooting guide
The dehumidifier
will not switch on.
• Make sure that themains lead is properly plugged in and
that there is power in thewall socket.
• The water reservoir is full or incorrectly fitted.
• The set humidity level has been reached.
The humidity is
not reducing.
• The dehumidifier has not been used long enough.
• Make sure that nothing is preventing theair in theroom
where thedehumidifier is used from circulating properly.
• The humidity level is not set low enough.
• Make sure that no outdoor air can enter theroom in which
thedehumidifier is being used.
• The ambient temperature is below 15 ºC.
• Is there aheat source in theroom which is raising
thehumidity?
Unusual noises
emitted during use.
• Make sure that theair filter is clean.
• The dehumidifier is tilted or standing on anuneven surface.
Error and protection
codes (shown on
thedehumidifier’s
display)
• AS: Defective humidity sensor. Turn off theair conditioner,
pull out theplug and plug it in again. If this does not solve
theproblem, contact aqualified service centre.
• ES: Defective temperature sensor. Turn off theair
conditioner, pull out theplug and plug it in again.
If this does not solve theproblem, contact aqualified
service centre.
• P1: Automatic defrosting in progress. Let thedehumidifier
be switched on until P1 no longer appears on thedisplay.
• P2: The water reservoir is full or incorrectly fitted.
Empty of refit it.
• E3: Other defects. Turn off theair conditioner, pull
out theplug and plug it in again. If this does not solve
theproblem, contact aqualified service centre.
To Next Page
Loading...
Need help?
General
