EasyManuals Logo

CO/Tech MDDG-20DEN3-QA3-UK User Manual

CO/Tech MDDG-20DEN3-QA3-UK
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
7
ENGLISH
Operating instructions
Note:
• Make sure that therubber plug in thedrain hose hole is securely in place before
turning thedehumidifier on if it is not to be used for continuous dehumidification.
• The water reservoir must be correctly fitted before thedehumidifier can be
switched on.
• Remember to empty thewater reservoir before moving thedehumidifier.
• The dehumidifier works best at normal room temperature, its efficiency is reduced
if theambient temperature falls to below 15 ºC.
• Let thedehumidifier operate continuously for 24 hours thefirst time it used.
See theContinuous operation section.
• If thedehumidifier is turned off and then turned back on again immediately,
it will take approximately 3 minutes to reach full power.
• Never use thedehumidifier without theair filter in place.
• If thedehumidifier is switched off by apower cut it will automatically switch back
on once thepower is restored.
Switching the dehumidifier on/off
1. Read all theinstructions in theSafety and Placement sections above.
2. Connect themains lead to awall socket with thespecifications listed in
part 1 of theSafety section above.
3. Turn thedehumidifier on by pressing the[ Power ] button.
4. Turn thedehumidifier off by pressing the[ Power ] button again.
Setting the desired level of humidity
Note:
• When thedehumidifier is switched on thedisplay shows thecurrent humidity in
theroom in which thedehumidifier is located.
• If thehumidity of theroom is 40 % and theappliance is set to maintain ahumidity
level of 60 %, theappliance will not operate.
1. Press [ - ] or [ + ] to set thedesired humidity. The humidity level can be set in
therange 35–85 % RH in increments of 5 %.
2. When thedesired humidity level has been reached thedehumidifier switches off
automatically.
Setting the timer
When thedehumidifier is switched on:
1. Press [ Timer ], thestop timer indicator lights up.
2. Set thedesired stop time by pressing or holding down [ - ] or [ + ]. Each press
changes thetime in 30-min increments up to the10-hour mark. Thereafter in
increments of 60 minutes.
3. Press [ Timer ] again, thestart timer indicator lights up.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CO/Tech MDDG-20DEN3-QA3-UK and is the answer not in the manual?

CO/Tech MDDG-20DEN3-QA3-UK Specifications

General IconGeneral
BrandCO/Tech
ModelMDDG-20DEN3-QA3-UK
CategoryDehumidifier
LanguageEnglish

Related product manuals