CO/Tech MDDG-20DEN3-QA3-UK User Manual

8
ENGLISH
4. Set thedesired start time by pressing or holding down [ - ] or [ + ].
5. After afew seconds thedisplay reverts to showing thecurrent humidity and
thetimer indicators light up to show that thetimer settings are activated.
6. The [ Timer ] button can be pressed at any time to check thesettings.
7. The timer settings can be changed at any time by pressing [ Timer ] and then [ - ] or [ + ].
• If thedehumidifier is switched off after thetimer settings have been made,
thesettings will be deleted.
• If thewater reservoir fills up (“P2” appears on thedisplay) while thedehumidifier is
operating and before theset timer time has been reached, thetimer setting will
be deleted.
When thedehumidifier is switched off:
1. Press [ Timer ], thestart timer indicator lights up.
2. Set thedesired start time by pressing or holding down [ - ] or [ + ]. Each press
changes thetime in 30-min increments up to the10-hour mark. Thereafter in
increments of 60 minutes.
3. Press [ Timer ] again, thestop timer indicator lights up.
4. Set thedesired stop time by pressing or holding down [ - ] or [ + ].
5. After afew seconds thedisplay reverts to showing thecurrent humidity and
thetimer indicators light up to show that thetimer settings are activated.
6. The [ Timer ] button can be pressed at any time to check thesettings.
7. The timer settings can be changed at any time by pressing [ Timer ] and then [ - ] or [ + ].
• If thedehumidifier is switched on after thetimer settings have been made,
thesettings will be deleted.
• If thewater reservoir fills up (“P2” appears on thedisplay) while thedehumidifier is
operating and before theset timer time has been reached, thetimer setting will
be deleted.
Automatic shut-off
• When thewater reservoir becomes full during normal use, thedehumidifier’s
compressor shuts off automatically.
• The fan continues for another 30 seconds to dry theinside of thedehumidifier.
• The dehumidifier beeps 8 times, the“Water Full” LED indicator flashes and “P2”
appears on thedisplay.

CO/Tech MDDG-20DEN3-QA3-UK Specifications

General

Brand	CO/Tech
Model	MDDG-20DEN3-QA3-UK
Category	Dehumidifier
Language	English