To Next PageTo Next Page
Need help?Do you have a question about the Coban GPS103-A and is the answer not in the manual?
Lists key functionalities and capabilities of the tracker device.
Instructions for the physical installation of the tracker unit.
Steps for inserting and setting up the SIM card into the device.
Guidance on properly powering on the tracker device after installation.
Explains the status indicated by the GSM and GPS LED lights.
Process to reset the tracker to its default factory settings via SMS.
How to modify the security password for accessing and controlling the device.
Method for setting up authorized phone numbers for device control and alerts.
Instructions for obtaining the tracker's location via a single SMS request.
How to configure automatic location reporting at specified time intervals.
Retrieves the device's location as a readable street address via SMS.
Enables audio monitoring through the tracker device by dialing in.
Switching between tracking and audio monitoring operational modes via SMS.
Notifies when the tracker's battery level is critically low.
Alerts the user if the tracker device is turned off.
Allows the user to send an emergency alert with location data by pressing the SOS button.
Sets virtual geographic boundaries for movement alerts.
Triggers an alert if the device moves from a stationary position.
Alerts when the device exceeds a configured speed limit.
Remotely disables the vehicle's engine to prevent operation.
Restores the vehicle's engine operation after remote shutdown.
Activates the security system, putting the tracker in an armed state.
Deactivates the security system, taking the tracker out of armed state.
Explains the operation of the optional remote control for model B.
Triggers when a car door is opened while the system is armed.
Triggers if the vibration sensor is activated while armed.
Alerts when the vehicle's ignition (ACC) is turned on while armed.
Configures the tracker to operate without audible alarms.
Describes how the tracker behaves when there is no GSM network service.
Allows querying the tracker for its current operational status.
Procedures for resetting the tracker's hardware modules.
Method to retrieve the device's unique IMEI number via SMS.
Instructions for setting the device's internal clock and timezone.
Configuration steps for enabling GPRS data transmission.
Configuration of the Access Point Name for GPRS connectivity.
Setting up user credentials for GPRS login.
Configuration of IP address and port for GPRS communication.
Switching the tracker's primary communication mode between SMS and GPRS.
Addresses issues with the device failing to start up.
Troubleshooting steps for when the device fails to make or receive calls.
Resolves issues where the device unexpectedly disconnects calls.
General
