To Next PageTo Next Page
Need help?Do you have a question about the Coban GPS304 and is the answer not in the manual?
General| Network | GSM/GPRS |
|---|---|
| GSM Frequency | 850/900/1800/1900MHz |
| GPS Sensitivity | -159dBm |
| Time To First Fix (Hot Start) | 1s |
| Tracking Sensitivity | -159dBm |
| Current Consumption (Tracking) | 80mA |
| Current Consumption (Standby) | 15mA |
| Battery | Rechargeable Li-ion battery |
| Humidity | 5% to 95% non-condensing |
| Voltage of car power system | 12V |
| Antenna Type | Built-in |
Explains the product's core functionality based on GSM/GPRS network and GPS satellites.
Lists the key features of the tracker, including design and tracking capabilities.
Details the process of installing the tracker unit and connecting wires.
Guides on how to correctly install the SIM card into the device.
Instructions for powering on the tracker device after installation.
Steps to initialize the device settings via SMS.
Procedure for changing the device's access password via SMS.
How to set up authorized numbers for device control and tracking.
Instructions for obtaining the device's current location via SMS or call.
How to enable continuous tracking at set time or distance intervals.
How to retrieve the device's location as a street address via SMS.
Explains using LBS for positioning when GPS signals are unavailable.
Instructions for switching between track and monitor modes.
Details the auto-logging feature to an SD card for tracking data.
How to load tracking data from the device to a monitoring platform.
Setting up forwarding of SMS messages to other specified numbers.
Procedure for checking account balance with the carrier via SMS.
Commands to remotely stop the vehicle's engine and resume power.
Details the functions of the remote controller for specific device models.
Instructions on how to arm the vehicle security system via SMS or remote.
How to activate silent mode for alarms, affecting siren behavior.
Instructions on how to disarm the vehicle security system.
Describes alarms triggered when the system is in arm state.
Behavior of alarms when the device is without GSM network coverage.
How to query the current status of the vehicle's systems via SMS.
Procedure to reset the device's GSM and GPS modules.
Configuration options for device sleep modes to save power.
How to retrieve the device's unique IMEI number via SMS.
Instructions for setting the device's local time zone.
Switching the device's communication protocol between TCP and UDP.
Guidance on configuring device parameters using a USB connection.
Detailed steps for configuring GPRS settings like APN and IP.
Activating a mode to reduce GPRS data consumption.
How to switch the device's primary communication mode between SMS and GPRS.
Configuring a specific number to receive auto-track SMS messages.
Information on accessing the web platform and PC tracking software.
Notification triggered when the device's battery level is critically low.
Alert sent when the external power source connected to the tracker is disconnected.
Notification when the device loses GPS signal, providing last known coordinates.
Emergency alert sent by pressing the SOS button on the device or remote.
Setting up geographical boundaries to trigger alerts when crossed.
Functionality to manage multiple defined geographical areas for tracking.
Alert triggered when the stationary device starts moving.
Notification sent when the vehicle exceeds a pre-set speed limit.
Alerts for ignition status changes (ACC on/off).
