570-2000, Rev. E, 453-2000 Handheld Programmer Operations Manual
The print function relies on the Stevens Creek Software application PalmPrint or
SCSPrint. Either PalmPrint.prc or SCSPrint.prc must be installed on the base Meazura
unit for printing to function. PalmPrint or SCSPrint are available from:
Stevens Creek Software, LLC
P.O. Box 2126
Cupertino, CA 95015
Fax: 1-603-698-4777
www.stevenscreek.com
Printing preferences are selected from the main Meazura screen by selecting
PalmPrint or SCSPrint and then choosing Infrared or serial connections, and choosing
an appropriate printer type. Poorly formatted or illegible text may be caused by
incorrect serial port speed or printer type selection. For more information contact the
printer software vendor.
6.7 Sarcalc Desktop
The Sarcalc Desktop application SarCalc Desktop V1.2 (or higher) may also be installed
on a PC (available as a free download at www.artex.net
). Once installed, the entire
Sarcalc or Artex database can be reviewed.
NOTE
: The Meazura unit must be Hot Sync'd with the Palm Desktop software to
load the database from the Meazura MEZ1000 to the PC.
Once sync'd, the database can be opened on the PC by starting the SarCalcDesk.exe
application and opening the database from the file menu. The Palm HotSync will
usually store the database file in C:\ProgramFiles\Palm\Artex\Backup\, where Artex is
the Meazura user name. Be sure to use the “Artex” user name whenever performing a
“HotSync”. All Artex provided software is loaded to the Meazura using this user name.
The database will be named SarcalcDB.PDB. If the Meazura MEZ1000 was set-up on
the PC with a different User Name than “Artex”, check the folder for that User Name to
locate the Backup file to find the Sarcalc and Artex database information.
Page 29
To Next Page
Loading...