COBHAM SAILOR 6194 - LAN Interface (X6)

Chapter 3: Connecting cables
20 LAN interface (X6)
LAN interface (X6)
Overview
There is one Ethernet (10/100 MB) connector on the Terminal Control Unit.
We recommend connecting to the slave unit, in order to reserve the free
LAN connectors for user interfaces on the master unit.
The Ethernet interface can be used to connect a computer and use the
easyMail program supplied on CD with the Terminal Control Unit, the
ThraneLink Management Application or a terminal program to access the
Terminal Control Unit or the connected SAILOR 3027.
Pin-out
The figure and table below show the connector outline and pin
assignments.
Note
To access the Terminal Control Unit through the LAN interface
you must know the IP address of the Terminal Control Unit. The
ThraneLink Management Application lists all connected units with
their IP addresses. For details, see Updating software on page 59.
You may also define a temporary IP address for the Terminal
Control Unit.
Pin number Pin function
1
Rx+
2
Rx-
3
Tx+
4
Not connected
5
Not connected
6
Tx-
7
Not connected
8
Not connected
RJ-45 female