5
Mi c rophone Co n n e ctor
Al l ows for co nve n i e nt re m oval of the micro p h o n e
plug when sto rage is re q u i re d .The micro p h o n e
MUST be co n n e cted to the unit at all times when in
u s e,for pro per ope rat i o n .
Sq u e l c h
This co nt rol is used to cut off or eliminate re ce i ve r
b a c kg round noise in the absence of an inco m i n g
s i g n a l . Adjust until the re ce i ver noise disappe a r s.
This will re q u i r e the incoming signal to be slight l y
s t ronger than ave rage re ce i ver noise.Fu rther cloc k-
wise ro t ation will increase the threshold leve l
which a signal must ove rcome in order to be heard.
Only strong signals will be heard at a maximum
c l oc kwise setting.
Microphone
Connector
O p e r a t i o n
4
Tu r ning on
Tu rn volume co nt rol cloc kwise to turn power on
and set the desired listening vo l u m e.
CB Ante n n a
Only a pro pe rly matched antenna sys tem will
a l l ow maximum power output.
In mobile installations (ca r s ,t ru c k s ,bo at s,e tc. ) ,
an antenna sys t em that is non-dire ctional should
be used.
When installed in a bo at,the tra n s ce i ver will not
o pe rate at maximum efficiency without a gro u n d
p l ate unless the vessel has a steel hull.Be fo re
installing the tra n s ce i ver in a bo at,consult yo u r
dealer for info rm ation re g a rding an adequate
g rounding sys te m .
Turning on
Your Radio
Operation
CB Antenna
No te
Co b ra loaded-ty pe ante n n a
m odels HGA 1000,HGA 1500,
and HGA 2000 are highly re c-
ommended for most installa-
t i o n s. Consult your Co b ra deal-
er for further details (or see
o rder form at the back of
this boo k ) .
3 - Way Combination An te n n a s
a re available which allow ope r-
ation of all three bands (AM-FM
& CB), using a single ante n n a .
Howeve r,use of this ty pe of
a n tenna usually results in less
than normal transmit and
re ce i ve range when co m p a re d
to a standard - ty pe "Si n g l e
Band" antenna designed for
CB only.
Squelch
19 DX III. LAYOUT(4478) 8/9/00 4:35 PM Page 4