Cobra 29 LX User Manual

Operation
Operation
17
16
Menu Mode
Menu Mode
Used to program special features. Menu/Enter
knob is used to move cursor to desired feature
to program.
Rotate Menu/Enter knob clockwise to navigate
menu levels.
Press Menu/Enter knob to select feature to be
programmed.
CB/WX
Note
Use Dim/Escape button to exit
from any routine back to CB
standby mode.
Setting the
Clock
Setting the Clock
Using the clock, alarm and countdown functions.
To set the clock, press Menu/Enter knob and
select Set Clock.
12:00 PM will appear in the display and the hours
will flash. Rotate Menu/Enter knob clockwise to
select desired hour and press to set.
The minutes will then flash. Rotate Menu/Enter knob
again to select desired minutes and press to set.
Once the minutes are set, AM or PM will then
flash. Rotate Menu/Enter knob again to select AM
or PM and press to set or scroll down to EXIT and
press to return to main menu.
SWR/CAL
NB/ANL
VOL SQ DYNAMIKERF GAIN DELTA TUNE
T BACK
SWR
CAL
OFF MIN
MINOFF
MAX
ESC
MEM SCAN
S/RF
M
E
N
U
P
U
S
H
E
N
T
E
R
SIG
RF
+30dB
1
1.5
2
3
CAL
3
5
7
9
SWR
TX
RX
NB/ANL
MEMWX !
ANL
S/RF
SWR
CAL
CH 9/
19
CB/WX /
DIM
SCAN
PA
EXIT
Level 1: Level 2:
Level 3: Level 4:
Level 5:
Note
Normal display will appear if
clock has not yet been set.
Note
Use Dim/Escape button to exit
from any routine back to CB
standby mode.
Setting the
Alarm
Setting the Alarm
Your 29 LX can be utilized as an alarm clock.
To set the alarm, press Menu/Enter knob and
select Set Alarm.
Rotate Menu/Enter knob clockwise to select Set
Alarm Time. Follow instructions above for setting
the alarm time and AM or PM.
Note
The clock should be connected
to constant 12V to run
continuously.

Cobra 29 LX Specifications

Weight and Dimensions

Weight	2540 g
Dimensions (WxDxH)	184 x 235 x 57 mm