English
4
Device Operation
Inserting and removing the Memory Card
Your camera comes with an 8GB Memory Card Preinstalled, but
it can be upgraded with up to 32GB with a different Memory
Card (not included.)
To remove the memory card, push the Memory card forward
gently until you hear a click, and the card should release.
To insert a different memory card, orient the card with the
“bumpy edge” facing down and press it in until you hear a click,
then release.
Your Dash Cam
Powering the Device On and Off
To turn the device on, press the POWER button.
To turn the device off, press and hold the POWER button
for three seconds.
Charging the device
You can charge the device with the included car charger,
or with a USB cable. The device will also run off of its own
internal battery for a short time.
NOTE: When the Car charger is connected,
the device will automatically power on and
start recording video.
Battery: The battery in this unit is intended
to operate the unit after power loss due to an
accident or crash. Note that while recording may
continue, the device was not intended for long-
term recording on battery power.
To Next Page
Loading...
