To Next Page

To Previous Page

Part 3 Installation

Commissioning

The following commissioning checks must be

carried out before the Range is handed over for use,

to ensure that the unit operates correctly and the

operator(s) understand the correct operating

procedure.

1. Before leaving the new installation;

a. Check the following functions in accordance

with the operating instructions specified in

the 'Operation' section of this manual.

 Lighting the Griddle.

 Lighting the Open Burners.

 Lighting the Open Burners. (F - Flame

Failure Option).

 Check the Low Fire Burner Operation.

 Light the Oven Pilot and Main Burners.

 Check the Oven Main Burner Thermostat

operation.

 Turning the Oven to ‘Stand-By’ Mode.

 Oven ‘Shut Down’.

b. Ensure that each operator has been

instructed in the areas of correct lighting,

operation, and shutdown procedure for the

appliance.

2. This manual must be kept by the owner for future

reference and a record of the Date of Purchase,

Date of Installation and Serial Number of the

Appliance recorded and kept with this manual.

(These details can be found on the Rating Plate

rating plate located on the front lower corner of

the R/H side panel.

NOTE:

If for some reason it is not possible to get the

appliance to operate correctly, shut off the gas

supply and contact the supplier of this unit.

Cobra CR6 User Manual

Other manuals for Cobra CR6