Cobra CR6 User Manual

18
Part 6 Gas Conversion
Gas Regulator
NOTE:
The regulator supplied is convertible between
Natural Gas and LP Gas, but it’s outlet pressure is
fixed ex-factory and is NOT to be adjusted.
1. Ensure that the gas supply is turned 'Off' at the
mains.
2. Unscrew the hexagonal cap (23 mm A/F) from
the regulator.
3. Un-clip the plastic pin from the cap, reverse the
pin and re-fit it back to the cap the correct way
for the gas type to be used. (Either ‘LP’ or ‘NAT’
should be visible on the flank of the pin once
re-fitted to the cap).
4. Screw the cap back into the regulator hand
tight only.
Gas Type Identification Label
On completion of the gas conversion, replace the
gas type identification label located at:-
- The rear of the appliance, above the gas
connection.
- Beside the rating plate.
Commissioning
Before leaving the converted installation;
1. Check all gas connections for leakages using
soapy water or other gas detecting equipment.
2. Check the following functions in accordance
with the operating instructions specified in the
'Operation' section of this manual.
 Lighting the Open Burners.
 Lighting the Open Burners. (F - Flame Failure
Option).
 Lighting the Griddle.
NOTE, Pin rotated
for Natural Gas
NOTE, Pin rotated
for LPG
 Oven Pilot Ignition.
 Oven Main Burner Thermostat.
 Turning the Oven to ‘Stand-By’ Mode.
 Oven ‘Shut Down’.
3. Ensure any adjustments done to components
that have the adjustments / settings sealed (e.g.
paint sealed) are re-sealed.
NOTE:
If for some reason it is not possible to get the
appliance to operate correctly, shut off the gas
supply and contact the supplier of this appliance.
WARNING:
DO NOT USE A NAKED FLAME TO CHECK FOR GAS LEAKAGES.

Cobra CR6 Specifications

General

Brand	Cobra
Model	CR6
Category	Ranges
Language	English