6. Install the PV cap and load (wave) spring.
7. Install the PV clamp bracket by inserting it into the frame while
compressing the load spring in the orientation shown.
8. Rotate the clamp handle down and secure with the bolt.
Solenoid Troubleshooting:
20 ohm
15 volts above ˜8200 RPM
Exhaust
The 2014 pipe was designed
and is produced by Pro Circuit.
The exhaust flange to pipe
sealing arrangements is as
shown. This seals better and
remains in position better
during installation. In 2014 they
are two ZCMOTE11 and one
ZCMUOR11.
Fuel & Air System
Carburetor:
Tools recommended for carburetor
service:
Small flat head screwdriver
WD-40
6mm socket
Your Cobra is equipped with an
adjustable carburetor. Some fine-tuning
may be needed according to weather
condition and altitude. Proper jetting is
very important for engine performance
and engine life. Serious damage to the
engine can occur if not properly
adjusted.
IDLE ADJUSTMENT:
On the each side of the carburetor, there
are two adjustment screws. The right
side screw with the knurled head is the
idle adjustment screw. To raise the idle,
turn the screw in clockwise (in 1/4 turn
To Next Page
Loading...