17
G100 USER AND FITTING INSTRUCTIONS
GB
7 - HOW TO CONFIGURATE POSITIVE PERIMETRICAL INPUT.
Enable line 6 on the basic tables function following the instructions written
on the reverse side (see paragraph 15 on “How to programme the G100
system” on www.cobra-at.com)
8 - ALARM RECORD.
When it is being disarmed, the system reports if there has been an
alarm by four acoustic and visual signals emitted by the direction
indicators and buzzer. Pay attention to the LED signals that remain
available until the next time the system is armed or until the ignition is
turned on. The signals (number of flashes) identify the cause of the
alarm.
9 - SYSTEM’S TECHNICAL CHARACTERISTICS.
WARNING !
This product is configurated to meet the requirements of
the European Directive for alarm systems. Utilisation of
the buzzer function is allowed only for markets outside
the European Community only. Activating this function
invalidates the EC Declaration of Conformity.
LED SIGNALS
CAUSE OF THE ALARM
1 flash doors/boot opened
ultrasonic volumetric sensor
triggered
3 flashes
bonnet opened
4 flashes
start -up attempts
(ignition key)
5 flashes
outside module disconnected
4310 siren disconnected
6 flashes
2 flashes
speed input sensor I addiotional
sensors triggered
satellite anti- theft disconnected
not used
7 flashes
8 flashes
9 flashes
10 flashes
not used
TECHNICAL CHARACTERISTICS OF THE SYSTEM
Rated power input voltage
Operating voltage
Consumption for standard configuration
(alarm with ultrasonic sensors, engine cut-off and LED 12 VDC)
9 / 16 VDC
- disarmed
- armed
< 13 mA
< 15 mA
Central operating temperature
Siren operating temperature
Acoustic power
12 VDC
- 40 / +85 °C
- 40 / +105 °C
> 118 dB(A) a 1 m
EUROPEAN DIRECTIVES
Commission Directive 95/56/CE of 8th November 1995
Commission Directive 2006/28/EC of 6th March 2006
Commission Directive 89/336/CEE of 3rd May 1989
- siren
> 115 dB(A) a 1 m
- loudspeaker
06DE2245D OK.pmd 09/09/2008, 10.0617
To Next Page
Loading...
Need help?
General
