Cobra microTALK MT 725 User Manual

OPERATION
Battery Installation
To Install or Replace Batteries:
1. Remove belt clip by releasing belt
clip latch and sliding clip Up.
2. Pull down on the BATTERY DOOR
LOCK TAB to remove the battery
compartment cover.
3. Insert the rechargeable NiMH battery pack (part No. FA-BP) according to
instructions indicated on battery pack.
NOTE: Four high-quality alkaline (4) AAA batteries can
also be used. Position batteries according to
polarity markings.
4. Replace Battery Compartment cover and belt clip.
Battery Pack Charging
Your microTALK
®
radio includes two (2) rechargeable
NiMH battery packs (part No. FA-BP) and a two-port
rapid desktop charger (part No. PA-CD).
Your two-port rapid desktop charger is capable of
recharging:
English
a. One (1) radio (with battery pack installed in
battery compa-rtment) and one (1) battery pack
using the included battery pack guide in the radio
charging well.
b. Two (2) radios (with battery pack installed in
battery compartment).
c. Two (2) battery packs using the included battery pack guides in the
radio charging wells.
You should fully charge the included rechargeable NiMH battery packs (part
No. FA-BP) before using your microTALK
®
radios for the first time.
NOTE: Estimated Operation Time On Full Charge: 15 Hours.
This rechargeable battery must be recycled or disposed of properly in
compliance with all applicable laws. It must not be thrown away with
household rubbish.
NOTE: Do not put batteries into fire or expose to high heat. They may
explode.
Remove Belt Clip
Lock Tab
Insert Batteries
Battery Packs &
Desktop Charger
One Battery Pack &
One Radio

Cobra microTALK MT 725 Specifications

General

Brand	Cobra
Model	microTALK MT 725
Category	Two-Way Radio
Language	English