Push and release button again.
MAIN CHANNEL will flash and only the
icon will remain flashing.
Push and release button until icon and
a memory location flashes.
Select memory location you wish to change by
pushing and releasing either button.
(Use MEM 6 for this example).
3
Select desired main channel you wish to store
(1-8) by pushing and releasing either
button.(Use CHANNEL 8 for this
example.)
5
Advanced Features
23
Note
Once you enter memory
mode you can talk and lis-
ten to any channel you
select after programming is
complete. See Using
Memory Locations section
on page 26.
continued
Advanced Features
22
Programming Memory Locations
Your MicroTalk has 10 memory (0-9) locations for
storing your most frequently used channels.
Rotate ON - OFF Volume Control clockwise.
An audible “tone”will indicate that the unit is
on.The LCD will go through a 3-second self-
test and then go to operational mode.
Programming
Memory
Locations
2
1
4
PMR300-UK.qx copy 6/21/99 11:45 AM Page 22
To Next Page
Loading...
Need help?
General
