Advanced Features
29
Advanced Features
28
Note
The Mi c ro Talk “ze ros out”t h e
s u bchannels to allow sca n-
ning of the main channels.
Scan Function
Scan Function
Push and release button until icon and
main channel flashes.
Rotate ON - OFF Volume Control clockwise.
An audible “tone”will indicate that the unit is
on. The LCD will go through a 3-second self-
test and then go to operational mode.
2
1
Push and release either button and the
unit will begin scanning the main channels.
Unit will continue to scan all main channels
and stop if an incoming transmission is
detected.
3
4
Your MicroTalk will pick it up for 10 seconds.
Within 10 seconds you can:
Push and hold button and talk.Your radio will
return to operational mode on that channel.
or...
Push and release either button to re-
scan the main channel.
or...
Proceed to subchannel scan on next page.
A
B
C
continued
PMR300-UK.qx copy 6/21/99 11:45 AM Page 28
To Next Page
Loading...
Need help?
General
