Voice Activated Transmit (VOX)
In VOX mode, your microTALK
®
radio can be used “hands-free,” automatically
transmitting when you speak. You can set the VOX sensitivity level to fit the
volume of your voice and avoid transmissions triggered by background noise.
To turn VOX mode on or off:
1. Press the Mode button until the VOX icon flashes on the
display. The current On or Off setting is displayed.
2. Press the Up or Down button to turn VOX On or Off.
3. Choose one of the following:
a. Press the Mode button to enter the new setting and
proceed to other functions.
b. Press the Talk or Call button to enter the new setting
and return to Standby mode.
c. Do not press any buttons for 6 seconds to enter the
new setting and return to Standby mode.
To set VOX sensitivity:
1. Press the Mode button until the VOX icon flashes and
the current sensitivity level is displayed.
2. Press the Up or Down button to change the setting.
3. Choose one of the following:
a. Press the Mode button to enter the new setting and
proceed to other functions.
b. Press the Talk or Call button to enter the new
setting and return to Standby mode.
c. Do not press any buttons for 6 seconds to enter the
new setting and return to Standby mode.
Set DCS Privacy Codes
To select a DCS privacy code:
1. After selecting a channel (only be available on channel
1~16), press the Mode button until the DCS icon appears
and the small numbers flash on the display (00 through 83).
2. Press using the Up or Down button to select a DCS privacy code. You can
hold the Up or Down button for fast advance.
3. When your desired DCS privacy code is displayed, choose one of the
following:
a. Press the Mode button to enter the new setting and proceed to other
functions.
b. Press the Talk or Call button to enter the new setting and return to
Standby mode.
c. Do not press any buttons for 6 seconds to enter the new setting and
return to Standby mode.
DCS Privacy Code
Up/Down Button
Up/Down Button
Up/Down Button
Mode Button
Mode Button
Mode Button
10 11
VOX Icon
VOX Sensitivity Level
If CTCSS is turned on at the channel selected,
the display will flash the DCS icon and “OFF.”
To switch from CTCSS to DCS, press the Up
or Down button while the display is flashing
“OFF.” The display will then show the small
numbers flashing and you will then be able to
proceed to step 2.
The current VOX sensitivity level is displayed
with letters “L” and a Number 1 through 5,
with Number 5 being the most sensitive level
and Number 1 being the least sensitive level.
To Next Page
Loading...
