Cobra XRS 9940

~ NOTES
IntelliMute may not work with some vehicles because it cannot sense the
engine's revs. In such cases, you can reduce unwanted audio alerts by using
Auto Mute and City mode when appropriate.
~ NOTES
The rev point must be reset if you use your detector in a different vehicle.
~ ~~~~~nitiallY choosing your IntelliMute activation point, a setting of approximately
300 to 600 RPMs above idle is recommended. You can reset the activation point
at any time to fit your individual preferences and driving style.
~'g~tO~'tq~tt";i~,pofD~w,m~i~v;~;;~;df',viicr~j~:~~i~r~f7
' •. ,91'ld,idJingtQaVQid)a,colfisi(,m,,<hlringtgeJtQc-es§; "'. "" .. ,,' ..... ',)" ... ' >;(' ,'" /'"
;, "::':' -:: ;',,':,,:. ::'<' ;- ., .. 'c' " ,:',,',',,' ,,'. . ".:. ':.".:' '.•. ",: ,>.' ": ':':':.:',c- ;' ': "":. "',,,'!:, .. ::> :::..: .•.. , : ."":"" ':' ':":': .. :..: :: ;:',::.;: : ; ,. ': ' ',i, ,: : :.:.; .. : .. :.: .. : .. : <:.:_,;"-' :,:. ::: ~:,.::'- ~ ~: ," :,/;::::,y;,>:~:,/,
Set IntelliMute
After the detector is installed in your vehicle and the unit is turned on,
advance through the User Settings Programming to the Set IntelliMute
setup screen where the activation point can be set.
Setting the activation point progresses from the setup screen shown
on the User Programming Menu Guide (see page 34). From that screen:
1. Press the Mute .... button to begin the setting process.
2. Press and hold the vehicle accelerator at the desired engine RPMs.
3. Press the Mute .... button to complete the setting process.
The system will store the engine RPM setting and provide a completion
message on the display as well as a tone or voice message.
~ NOTE
If the unit is unable to sense usable pulses within three seconds or if you do not
set a rev point within 30 seconds of beginning the setup, IntelliMute will indicate
an error. If you do not try again within five seconds, it will automatically turn off.
The unit will provide corresponding messages for these conditions.
Once an activation point has been set, you can easily change it by going
directly to Set IntelliMute in User Settings Programming and repeating the
three-step setup process.
Nothing Comes Close to a CobrctJ ~