Cobra XRS 9940

~ Important Compass Information
~~
Your Detector "
Turning On and Calibrating Your Compass
The compass in your radar detector must be turned on and be calibrated before it will show on the
display and give accurate directions. The factory default for Compass is off. Be sure it is turned
on before calibrating.
To determine direction, the compass detects the weak magnetic field of the Earth. It also detects
the different magnetic fields produced by your vehicle. your audio speakers, and other installed
electronics. Calibration allows the compass electronics to measure and store information about
all magnetic fields in your vehicle so that it can ignore them!
Dim. Button @- .
Mute.... Button@· .
....
@Menu/Save Button
... @ City ~ Button
To Calibrate the Compass
Before calibrating compass, select the location where the detector will be mounted.
Tone Visual Display Voice
Press the Menu/Save button
to enter the EasySe
Programming mode.
Press the Dim ~ button to
enter the User Settings mode.
Press the City ~ button
repeatedly until SHOW
COMPASS appears in the
display.
Press the Mute T button to
turn on compass.
Press the City ~ button to
advance to calibration mode.
3 beeps
1 beep
None
1 beep "on"
2
beeps "off"
None or
1 beep
Initial programming
screen
CITY MODE
Sequential setting
options
MAGNETIC
COMPASS
CALIBRATE
COMPASS
PRESS ~
DRIVE 2 CIRCLES.
I Menu
I User Settings
None
Compass On
None
(Continued on Back Side)
Prmled In Chma
Part No 4BO·445-P
VerSion A