Your quick guide to
Baha Attract System
Attaching the Baha SoftWear Pad
1. Remove the old pad from the magnet.
Ensure you remove any adhesive glue
left behind.
2. Remove the cover sheet on the new
pad to expose the adhesive surface.
3. Attach the pad to the magnet. Make
sure it’s centralised and covers the
entire magnet surface.
4. Remove the remaining cover sheet
from the pad before you start wearing
the magnet.
Cleaning
Keep your magnet clean by using a soft
wipe. Do not use running water.
You should change the Baha SoftWear
TM
Pad regularly, when it’s worn out or
damaged, or if an accumulation of dirt
or moisture on the pad cannot be wiped
o.
If you experience a gradual deterioration
in wearing comfort (and if changing
the Baha SoftWear Pad does not help),
contact your hearing health professional.
Attaching your sound
processor to the
magnet
Hold the magnet with
one hand or place it on
a at surface. Hold the
sound processor with
the buttons positioned
upwards, tilt it, and
gently snap it into place.
Placing and removing the sound processor
1 2
3 4
Make sure that the arrow
on the magnet is pointing
upwards and then place
the magnet over the
implant behind your ear.
For optimal retention,
make sure there is not
too much hair underneath
the magnet when placing
it over the implant.
To remove the sound
processor, grasp it
with the magnet still
attached and gently pull
it away. To remove the
sound processor from
the magnet, place one
nger under the sound
processor and gently tilt
until it releases.
14 15
To Next Page
Loading...
