Remote Microphone Connection Procedures for the Kanso
with Cochlear Mini Mic 2+ as Transmitter
1. Pair the MM2+ to the Kanso (pairing only needs to be done once, unless MM2+ has been paired to another processor)
a. Turn off the Kanso by pressing and holding the button for 5 seconds until the indicator light turns a steady orange, then release the
button.
b. Turn on the MM2+ by pressing the ON/OFF button until the LED turns green, then release the button.
c. With the tip of a ballpoint pen, press the pairing button once. The LED will flash yellow. Within 20 seconds, turn on the Kanso by
pressing and holding the button until the LED turns green, then release the button.
2. The LED on the Kanso will blink blue, which indicates pairing is successful.
3. Activate STREAMING on the Kanso by pressing and holding the Kanso button for 3 seconds until a 3-tune melody is heard by the student
and the LED blinks blue.
To Next Page
Need help?
General
