Microphones
1. Turn o ReSound hearing aid and
Cochlear Nucleus 6 Processor
2. Turn on microphone
Note: The LED will flash yellow
while device is in pairing mode
for 20 seconds.
Note: When bimodal pairing, first ensure hearing devices are programmed to opposite ears.
20
seconds
Note: The LED will flash blue to
show pairing was successful.
Note: The LED will flash blue to
show pairing was successful.
Note: The LED will flash yellow
while device is in pairing mode
for 20 seconds.
TV Streamers
1. Plug power and audio cables into TV
Streamer and connect to audio source
20
seconds
3. Press pairing button 4. Turn on ReSound hearing
aid, pause 2 seconds, then
turn on Nucleus 6 Processor
2. Turn o ReSound hearing
aid and Nucleus 6
3. Locate and press the pairing
button on back by the clip
1. Turn on ReSound
hearing aid then
Nucleus 6 Processor
2. Turn on
microphone or
turn on TV
Streaming to
one or both
hearing devices
Note: Streaming
must be started and
stopped on each
device individually.
Long-press the upper
button on your sound
processor once.
Microphones and TV Streamers
A. Nucleus 6 Processor
A. Press and hold the push
button on your ReSound
Hearing Aid for 3 seconds.
OPTION
OPTION
B. CR210 Remote Control
Long-press the Telecoil
button. Audio will start
streaming through the
microphone.
OPTION
C. Using CR230
Remote Assistant
OPTION
Long-press the
Telecoil button.
4. Turn on ReSound hearing
aid, pause 2 seconds, then
turn on Nucleus 6 Processor
B. Using ReSound Unite Remote
If you have a ReSound Unite™ Remote
Control (optional), simply press the
streaming button on this Remote Control.
OPTION
Wireless Pairing & Streaming – Cochlear
™
Nucleus
®
6 and ReSound
Maximize your hearing with both ears
1
1
Wolfe, Jace. “Why Two Are Better Than One.” Presented at ACIA 2014, Nashville, TN.
Switch on
Note: Ensure microphone
is charged.
To Next Page
General
