Cockshut 30 - Oil Filter; Changing the Oil Filter Element; Important: Use Quality Elements

18 Operating In stru ctions for Cockshu tt "30" Tr a ctor
~ P LA T E
No.
<, C.13-46
••
•
-
••
OIL FILTER
PL ATE No. C·1 3-46
Clean oil in an . engine insures that the bea rings will be properly lubricated th us keeping
them cool and giving them a long life. However, all engi nes
form sludge while in opera-
tion and minute particles of
dirt also accum ulate in the crankcase; as a result, acids,
gums, varnish, and
other by.products are pres ent .
To remove these harmful substances a high capacity filter is used which under normal
conditions will remove the
dirt, etc., for aro und 120 hours of operation; aft er this time
the
dirt , etc., starts to plug t hecartridg e and soon it will be inoperative.
Every 100 hours,
as outlined above, change the elem ent as follows:
(1) STOP ENGINE -
(2) Drain filter by removing drain plug at bottom of oil filter as indicated by arrow (1) .
(3) Remove oil filter cap as indicated by arrow (2) .
(4) Remove
air cleaner cup as indicated by arrow ( 3).
(5) Wipe dirt off of oil filter cap, unscrew clamping tee screw and remove filter top as
indicated by
arrow (4).
(6) Remove and discard old elem ent as indi cated by arrow (5) ; use a clean rag and wipe
out any sludge remaining in.bottom of shell as indicated by arrow number (6); in-
spect new element and replace as
indicat ed by arrow number (5) .
(7)
Start engine and check filter for oil leaks, letting th e engine run for a few minut es
to allow
filt er to fill with oil.
(8) Check oil level and add sufficient to rep lace the amount which was fed into filt er.
(9) IMPORTANT - Do
not use cheap or su bstitute oil filter elements as th ey may be
inf erior in quality, and poorly packed and co ntain foreign substances. Always carry
extra elements on hand.
••
https://tractormanualz.com/