Cocktail Audio X10 - For SPDIF(Optical); For Sub Woofer

25
5-3-4-2. for Sub Woofer
When you connect a bookshelf speaker(passive) into the Speaker Out connector of the X10 and a
sub-woofer into the Line Out of the X10 simultaneously, set SPDIF to OFF, and set Speaker Out to
ON(Sub woofer) see images below.
5-3-4-3. for SPDIF(Optical)
When you want to connect an external amplifier or a decoder to the SPDIF(Optical) connector of
the X10, set the Speaker Out as OFF(Headphone) and set the SPDIF to PCM 2ch, Passthrough,
Frequency 48Khz or Frequency 96Khz, see below.
Set Speaker Out as OFF
Set as PCM 2ch
z Volume controllable by X10’s remote control
z Audio output :
File resolution Audio output
Over 96Khz 96Khz
96Khz Original resolution
Below 96Khz Original resolution
Set as Passthrough
z Volume NOT-controllable by X10’s remote control
z Audio output : Same as PCM 2ch like above
Set as Frequency 48Khz
z Volume controllable by X10’s remote control
z Audio output : 48Khz