To Next PageTo Next Page
Need help?Do you have a question about the CoCo APIR-2150 and is the answer not in the manual?
General| Brand | CoCo |
|---|---|
| Model | APIR-2150 |
| Category | Security Sensors |
| Language | English |
Read important safety information before product installation.
Remove screws to open the battery compartment of the sensor.
Place 2x 1.5V AAA alkaline batteries in the battery compartments.
Program the transmitter code into a COCO receiver's memory.
Slide LEARN switch to confirm code pairing with receiver.
Configure the time delay before the transmitter sends an OFF-signal.
Select one of three light sensitivity levels for the sensor.
Tighten all screws to ensure the sensor housing is waterproof.
Adjust the sensor's horizontal detection angle by modifying plastic screens.
Affix the holder and place the motion sensor into it at the desired location.
Loosen, point, and tighten the clamp screw to set the sensor's direction.
Learn how to send an OFF-signal to delete a code from receiver memory.
