Compliance
30 Automatic Tuning Whip Antenna 9350 Installation Handbook
FCC compliance
FCC Part 15 compliance
Any modifications made to the 9350 Automatic Tuning Whip
Antenna that are not approved by the party responsible for
compliance may void your equipment’s compliance under
Part 15 of the FCC rules.
The 9350 Automatic Tuning Whip Antenna has been tested
and found to comply with the limits for a Class B device,
pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
switching the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• reorient or relocate the receiving antenna
• increase the separation between the equipment and
receiver
• connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
• consult the dealer or an experienced radio/TV technician
for help
To Next Page
Loading...
