Code 3 DEFENDER TriCore User Manual

10
PROBLEM
TriCore Front Module
not operating.
TriCore Corner Module
has one head out.
Cruise Lights do not
operate
POSSIBLE CAUSE
a. Front and/or Rear Cut function
powered.
a. Defective module
b. Cable/Connector unplugged
a. Defective module
b. Cable/Connector unplugged
a. No power on Cruise wire
b. Another Central Controller Function
is on.
SOLUTION
a. Remove power (turn off) Front
and/or Rear Cut
a. Replace module.
b. Check cable & connector
a. Replace module.
b. Check cable & connector
a. Connect Cruise wire to switch
b. Turn off other functions.
TRICORE LIGHT HEAD
TROUBLESHOOTING GUIDE
Troubleshooting
All DEFENDER Lightbars are thoroughly tested prior to shipment. However, should you encounter a problem during installation or
during the life of the product, follow the guide below for information on repair and troubleshooting. Additional information may be
obtained from the factory technical help line at 314-996-2800.
Note: LED light heads must be replaced as a module. There are no user serviceable parts. Warranty is void if module is disassembled
QUESTIONS
Are all heads
out in front or in
back, and not just a
single module out?
Yes
No
NA
NA
Any disassembly of any of the TriCore light heads will result in loss of warranty coverage on the
equipment.
WARNING!
Notes:

Code 3 DEFENDER TriCore Specifications

General

Brand	Code 3
Model	DEFENDER TriCore
Category	Automobile Accessories
Language	English