4
Using Your Remote Transmitter
Arming
the Security System
To
arm the system, exit the vehicle,
chse
all doors, then -press· the ARM button. The parking lights
wi!! flash twice, indicating the system
is
armed. The doors will also lock
at
this time
(if
equipped and
connected). If ARM is pressed again within 20 seconds the siren-- will chirp twice. The status
indicator (red warning light on the dash)
will
blink steadily,-anee per second.
Pre-arm Mode
If the siren chirps and the parking lights flash
only·
once, this indicates that the vehicle courtesy light
is
on,
or
that an entrance is not closed securely. Check
to
see that doors, hood, and trunk are
properly closed. Once all entrances are secured (and the courtesy light is off), the system
will chirp I
flash again. The system is now fully armed. (If the entrance Is not secured within 4 minutes, the
system will arm and ignore the unsecured entrance until it Is closed.)
Disarming the Security System
To
disarm the system, press the DtSARM button. The parking lights will flash once, and the doors
will
unlock (if equipped and connected). If the DISARM button
is
pressed again within
20
seconds
the siren
will chirp once. The courtesy light will turn on for 1 minute,
or
until the vehicle is started.
Attempted
IntrusIon IdentifIcation
If the siren chirps four times when disarming, this indicates that the system was triggered in your
absence. The status indicator
will also flash rapidly. Perform the following operation
to
determine the
protected zone that triggered the system:
• After disarming, press the emergency override button.
The siren will chirp to indicate the cause
of
the alann
trigger:
• Throughout this manual, 'press' refers to preSSing for less than 1 second; 'press and hold' refers to pressing for
more than 1 second.
"Siren'
also refers to the vehicle horn If it Is used
as
the alarm sounding device.
NOTE:
If you have chosen the Silent Arming Option, the siren will not sound when arming
or
disarming until the
appropriate button is pressed a second time.
.